Equipment Controls; Control Panel Pictograms - Walter SURFOX 204 Manuel De L'utilisateur

Masquer les pouces

Table des Matières

Les langues disponibles

Safety instructions

Amperage

Before connecting this unit, check that the amperage

shown on the rating plate is the same as the power supply.

Operating this unit on an amperage other than specified on

its rating plate may result in personal injury to the user and

damage the unit.

Preventive maintenance

After use, allow the tip to cool and remove the cleaning pad.

Neutralize with SURFOX-N and rinse the cleaning pad and

wand tip with water and dry. Clean dust and dirt deposits

from the exterior of the unit. Keep all airflow vent openings

free of any obstructions. Clean the power cord to prevent

deterioration and check for possible damage to cord and

plug.

Note: Damaged cords must be replaced immediately by

qualified personnel only. Refer to Spare Parts List for the

ordering number.

Transportation

Before transporting the machine, make sure the cleaning

solution reservoir and supply line are completely empty

and all connecting lines disconnected. The machine must

be carefully packed in a suitable container and properly

protected. WALTER will not be held responsible for any

damages resulting from leaked cleaning solution or rough

handling.

Storage

If the machine is to be stored for any length of time, the

cleaning solution reservoir and supply line must be emptied,

cleaning pad removed (neutralized, rinsed and left off) and

the tip neutralized, rinsed and dried. Store in a dry

safe place to avoid damage, especially to the electronic

components.

Waste disposal

Dispose of residual waste in compliance with Federal,

Provincial, State and local environmental regulations. Refer

to WALTER Material Safety Data Sheet of the SURFOX

electrolyte cleaning solutions.

Extension cord

When an extension cord is needed, use wire size 14 (AWG)

for up to 50 feet (15 meters) and size 12 (AWG) for 50 to

100 feet (15 to 30 meters).