Introduction; Voltage; Extension Cord; Technical Data - Walter BIG BUFF III Guide De L'utilisateur

Safety Warnings Specific for Sanding Operations:
a) Do not use excessively oversized sanding disc paper. Follow
manufacturers recommendations, when selecting sanding paper.
Larger sanding paper extending beyond the sanding pad presents
a laceration hazard and may cause snagging, tearing of the disc or
kickback.
Safety Warnings Specific for Polishing Operations:
a) Do not allow any loose portion of the polishing bonnet or its
attachment strings to spin freely. Tuck away or trim any loose
attachment strings. Loose and spinning attachment strings can
entangle your fingers or snag on the work piece.

INTRODUCTION

Your WALTER power tool is precision built to meet the highest industrial
standards. For maximum performance and longest tool life, follow the
operating instructions and service procedures outlined in this manual.
This tool is CSA certified.
This tool is double insulated, it does not have to be grounded.
It may be safely operated from a grounded or ungrounded
receptacle. It is supplied with a 2-conductor power cord and
a polarized plug (one blade wider than the other). The plug
will fit only one way into a polarized outlet. If the plug does
not fit, have the outlet replaced by a qualified electrician. If an
extension cord is necessary, only one that is polarized must be
used. Do not change the plug in any way.
In order to maintain the safety features of the double insulation, the
housing must not be drilled to affix nameplates or the like. Self-adhesive
labels may be used for this purpose.
8

VOLTAGE

Before connecting the tool, make sure that the voltage shown on the rating
plate is the same as the power source.
Operating the tool on a voltage other than specified on its rating plate, may
result in personal injury to the user and damage to the unit.

EXTENSION CORD

When an extension cord is required, use one that is sufficient for the power
requirement of the tool. Extension cords of inadequate wire size cause a
serious drop in voltage, loss of power and possible motor damage. To limit
line voltage drop to a safe level, refer to the following table:
Length in meters 8
Length in feet 25
Wire size AWG 14
NOTE: Extension cords that are used outdoors must be approved for outdoor use.

TECHNICAL DATA

MODEL 6265 C
Voltage .........................120 V AC; 60 Hz
Amperage .....................12
No-load speed ..............POS.A POS.B POS.C POS.D POS.E POS.F POS.G
.....................................2,000 2,800 3,800 4,700
Spindle Thread .............5/8" -11 NC
Weight .........................2,66kg - 5lb. 14oz
MODEL 6265 C
Voltage .........................220 - 240 V AC; 50 - 60 Hz
Amperage .....................7,2
No-load speed ..............POS.A POS.B POS.C POS.D POS.E POS.F POS.G
.....................................2,000 2,800 3,800 4,700
Spindle Thread .............M14
Weight ..........................2,66kg - 5lb. 14oz
15 23 30
50 75 100
14 12 10
5,400
5,400
9
6,400 7,300
6,400 7,300