Control Panel; Main Power Switch; Wand Selector Switch; Solution Pump Switch - Walter SURFOX 204 Manuel De L'utilisateur

Control panel

A) Main power switch
Turns the main power to the unit ON
and OFF.
B) Wand selector switch
Marking and etching wand selector.
Select this icon when using a marking/
etching wand which has been plugged into
the accessory outlet. Select AC for marking
and DC for etching. Preset at 6 amps.
Mini wand selector. Select this icon
when using the mini wand which has been
plugged into the accessory outlet. Select
AC for cleaning and DC for polishing. Preset
at 12 amps.
Hand wand selector. Select this icon
when using the hand wand attached to the
SURFOX unit. Select AC for cleaning and
DC for polishing.
Large insert selector. Select this icon
when using the large insert which has been
plugged into the accessory outlet. Preset at
15 amps.
The electrochemical cleaning AC mode
has 3 settings: Low (6 amps), Medium
(9 amps), High (12 amps)
C) Solution pump switch
Manual pumping mode. Choose the man-
ual pumping mode to control the amount of
solution pumping to the tip. Hold the hand
wand ON button down to pump solution to
the tip. Release the ON button to stop the
pumping cycle. Always use enough solution
to keep the cleaning pad wet. Too little solu-
tion will reduce the cleaning pad life.
Automatic pumping mode. To start the
automatic pumping mode, press the ON
button on the wand. Once it is activated,
it will automatically pump the liquid. The
quantity of liquid can be selected from less
to more. Pumping will continue in this mode
until the OFF button is pressed.
A
B
F
D) Indicator lights
Power ON indicator. Green light is on
when the unit is plugged in and the main
power switch is turned on.
Hand wand power ON indicator. The
yellow light goes ON when the hand wand
ON button is pressed and there is power
to the tip. Power to the tip is OFF when the
hand wand OFF button is pressed.
Low solution level indicator. When
solution level is low, the red indicator light
will go on.
E) Accessory outlet
Outlet for optional mini wand or
marking/etching wand. The marking/etch-
ing wand is used to permanently etch/mark
your company name, logo, part
number or other desired information onto
stainless steel surfaces. The mini wand
is used to access hard to reach areas for
cleaning and passivating, which are too
small for the hand wand.
4
Control panel
C
D
E
SURFOX 204 User's Guide
7