Practical Advice; Maintenance And Service; Maintenance And Cleaning - Berner BRD-HT Notice Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Right rotation: To drill and to drive in screws,
press the rotational direction switch (4) through to
the left stop.
Left Rotation: To loosen and unscrew screws and
nuts, press the rotational direction switch (4)
through to the right stop.
Switching on/off
English
To start the power tool, press and hold the on/off
switch (5).
Press the lock-on button (6) to lock the on/off
switch (5) in this position.
To switch off the power tool, release the on/off
switch (5); or, if the switch is locked with the lock-
on button (6), briefly press the on/off switch (5)
and then release it.
Adjusting the Speed
English
You can adjust the speed of the power tool when
it is on by pressing in the on/off switch (5) to vary-
ing extents.
A light pressure on the on/off switch (5) results in
a low rotational speed. Increased pressure on the
switch causes an increase in speed.

Practical advice

English
Pull the plug out of the socket before carry-
u
ing out any work on the power tool.
Only apply the power tool to the screw/nut
u
when the tool is switched off. Rotating tool in-
serts can slip off.
When drilling into metal, only use sharpened HSS
drills (HSS = high-speed steel) which are in per-
fect condition. The Berner accessory range guar-
antees appropriate quality.

Maintenance and Service

Maintenance and Cleaning

Pull the plug out of the socket before carry-
u
ing out any work on the power tool.
To ensure safe and efficient operation, al-
u
ways keep the power tool and the ventilation
slots clean.
In order to avoid safety hazards, if the power sup-
ply cord needs to be replaced, this must be done
by Berner or by an after-sales service centre that
is authorised to repair Berner power tools.
In all correspondence and spare parts orders,
please always include the 6‑digit article number
given on the type plate of the power tool.
1 609 92A 5AJ • 8.10.19
Disposal
The power tool, accessories and packaging
should be recycled in an environmentally friendly
manner.
Only for EU countries:
According to the European Directive 2012/19/EU
on Waste Electrical and Electronic Equipment and
its implementation into national law, power tools
that are no longer usable must be collected separ-
ately and disposed of in an environmentally
friendly manner.
English
English
English
Do not dispose of power tools along
with household waste.
English
English | 15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

102458

Table des Matières