Applications; Battery Removal/Installation - Hitachi DH 24DV Mode D'emploi

English
5. Drilling holes (rotation only)
Drill chuck (13VLA)
Chuck wrench
13 mm drill chuck ass'y (include chuck wrench ass'y) and chuck (for drilling in steel or wood).
6. Driving Screws (rotation only)
Bit No. Screw Size
No. 2
No. 3
7. Dust cup, Dust collector (B)
Dust cup
Optional accessories are subject to change without notice.

APPLICATIONS

Rotation and striking mode
Drilling anchor holes
Drilling holes in concrete
Drilling holes in tile
Rotation only mode
Drilling in steel or wood
(with optional accessories)
Tightening machine screws, wood screws
(with optional accessories)

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latches
to remove the battery (see Figs. 1 and 2).
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery aligning both guide rail of battery
and body. Make sure the battery is fixed firmly.
11
Chuck adapter (D)
(SDS plus shank)
Bit Chuck adapter (D)
No. (SDS plus shank)
Length
3–5 mm 25 mm
5–8 mm 25 mm
Dust collector (B)
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Insert the battery into the charger as shown in Fig.
3. Make sure the battery is fully seated in the
charger.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.