PharmaJet Stratis Mode D'emploi page 9

NOTE: Do not dry fire the Injector.
a) Ensure the Reset Station Lid is fully open.
b) To prepare the Injector, place it into the Reset
Station. Push the Injector nose first into the Reset
Station, ensuring the blue retractable core retracts,
as shown in figure 1. Ensure the Injector is fully
nested in the Reset Station.
NOTE: Make sure the pin is in line with the Injector as
shown in figure 2.
c) FIRMLY push on the lid of the Reset Station. This
action is best performed from a standing position.
d) Continue to push down firmly against the resistance
until the lid closes completely, as shown in figure 3.
The Lid will lift indicating the Injector is charged.
NOTE: The Injector Hammer will be recessed when
charged.
uncharged
Workflow
1) Prepare Injector
figure 1
figure 2
figure 3
charged