Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
This fireplace is a zero clearance design. No
combustibles can be placed on the top
surface of the fireplace. Combustibles may
be installed to the edge of the unit.
A
B
16.0"
37.0"
Section 2: Recommended Power Supply Wire Specifications
For 120 volt installations use two conductor,
non-metallic sheath cable with ground wire
(3 wires total) for the incoming power supply
on fireplace inserts. Use the appropriate wire
to meet local and national electrical codes for
rated power consumption.
For 208/240 volt installations use three
conductor, non-metallic sheath cable with
ground wire (4 wires total) for the incoming
power supply on fireplace inserts. Use the
appropriate wire to meet local and national
electrical codes for rated power consumption.
Section 1: Framing
C
D
E
32"
32.4"
27.0"
Framing Specifications: Figure 1
E
D
Four mounting flanges on the sides of the unit
are provided to facilitate installation.
Insulation and vapor barrier should be placed
a minimum of 2 inches from the unit.
F
G
H
38.9"
36.0"
22.0"
H
G
F
J
Two conductor, non-metallic sheath cable with
ground wire (3 wires total) is recommended
for installation of a wall mounted thermostat
for use on fireplace inserts.
Recommended Wire and
Fusing Requirements
Use appropriate wire to meet local and
national electrical codes for rated power con-
sumption. All wire gauges should be
12 gauge with a dedicated 15 amp breaker.
E-3
I
J
K
28.0"
15.6"
55.0"
K
I
L
M
38.9"
38.9"
L
M
Publicité
Table des Matières
