Store The Engine; Spare Parts - IKRA BAS 3018 Manuel D'utilisation

Store the Engine

For periods of about 3 months or longer:
• Drain and clean the fuel tank in a well ventilated area.
• Dispose fuel properly in accordance with local environ-
mental requirements.
• Empty the fuel tank and screw the tank cap back on.
• Let the engine idle until it stops to free the carburettor
from fuel.
• Let the engine cool down (about 5 minutes)
• Remove the spark plug using a spark plug wrench.
• Fill a tea spoon of pure 2-stroke oil into the combus-
tion chamber. Pull the starter rope several times slowly
to distribute the oil inside the engine. Put the spark
plugback in.
• Thoroughly clean the machine - pay special attentionto
the sylinder fins and the air filiter.
• Remove the tool – clean and inspect it.
• Store the machine in a dry, high or locked location- out
of the reach of children and other unauthorized per-
sons.
• Do not store the tool and fuel can where petrol vapours
could come into contact with a naked flame or sparks
(e.g. not next to a cooker, oven or hot water boiler with
a pilot light). Always allow the tool to cool down before
putting into storage.
CAUTION: All maintenance work which is not detailed in
these instructions must be performed by an authorised
repair shop. In order to guarantee consistent and proper
operation, only ORIGINAL SPARE PARTS may be used.
Store the Tools
• For periods of about 3 months or longer:
• Remove and clean the saw chain and guide bar and
hedge trimmer, spray with corrosion inhibiting oil.
• If you use biological chain and bar lubricant com-plete-
ly fill the chain oil tank.
• If the Tool is stored separately, fit the protective cap
on the drive tube to avoid dirt getting into the coupling.
• Store the machine in a dry, high or locked location –
out of the reach of children and other unauthorized
persons.

Spare parts

Bar # 73044121
Chain # 73044122
GB-19