Connecting An External Amplifier / Active Subwoofer To Your System; C C T V - Cambridge Audio Incognito AH10 Guide D'installation

ADVANCED SYSTEM OPTIONS
Active subwoofer or
external amplifier
Twin screened
cable
Outlet with two
Phono/RCA sockets
IR10
Audio
(if available)
12 Incognito multi-room
SS10
CCTV hub
Video
Cat5
Connecting a a n e e xternal a a mplifier/active s s ubwoofer t t o
your s s ystem
Should extra amplification power, or, an active subwoofer be required,
a line level pre-amp output is provided on the back of the KP10.
Using high-quality audio interconnect cable, an external power
amplifier may be connected to the KP10 pre-amp output screw
terminals.
A fader function on the KP10 can be used to adjust the level
between the speakers connected to the KP10 and the external
amplifier/active subwoofer, so that the balance between the two
can be adjusted.

C C T V

A CCTV system may be connected to the Incognito Multi-Room system.
Connect the monitor/TV video signal output to the VH10 at the
CCTV IN socket located on the top surface of the unit allowing the
live video feed to be viewed in all connected zones.
If sound is also required, the audio signal output of the CCTV
system may be connected to the EXT / CCTV inputs on the AH10.
If the CCTV system is to be remote controlled connect an IR-1 infra-
red emitter to the ALL COMMANDS output on the AH10 and stick
the emitter over the IR receiver of the CCTV system. This will allow
the user to control the CCTV system from any room in the house.