Troubleshooting; Specifications - Sony CDP-D500 Mode D'emploi

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/Check that the player is connected securely.
/Make sure you operate the connected
component correctly.
/Adjust the playback level using the PHONE
LEVEL control.
The CD does not play.
/There's no CD inside the player ("-NO DISC-"
appears). Insert a CD.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 19).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 19).
The remote commander does not function.
/Remove the obstacles in the path of the remote
commander and the player.
/Point the remote commander at the remote
sensor in the left of the display on the player.
/Replace all the batteries in the remote
commander with new ones if they are weak.
/Set the Remote Protect of menu options to "RM
ENABLE" (see page 18).
The controls on the player do not function.
/Set the Key Protect of menu options to "LOCAL
ON" (see page 18).
The player functions incorrectly.
/The microcomputer chips may be operating
incorrectly. Turn off the player and turn it on
again.
EN
20

Specifications

Compact disc player
Frequency response 5 Hz to 20 kHz ± 0.3 dB (at 10 kilohms)
Signal-to-noise ratio
More than 100 dB (20 kHz LPF, IHF-A
weight)
Dynamic range More than 98 dB
Harmonic distortion Less than 0.004% (1 kHz, 0 dB, 20 kHz
LPF)
Channel separation More than 100 dB (1 kHz, 20 kHz LPF)
Analog outputs
Connector Type Output
impedance
ANALOG OUT XLR-3 100 ohms
(BALANCE)
ANALOG OUT Phono 200 ohms
(UNBALANCE)
jacks
PHONES Stereo 150 ohms
phone jack
Digital outputs
Connector Type
DIGITAL OUT XLR-3
(AES/EBU)
Phono jacks
DIGITAL OUT
(IEC-958)
Word input
Type Input
Connector
impedance
EXT SYNC BNC 22 kilohms/
INPUT 75 ohms,
switchable
Maximum Load
output level impedance
+24 dBs More than
10 kilohms
+ 9 dBs More than
10 kilohms
15 mW 32 ohms
Output Load
impedance
impedance
50 ohms
110 ohms
(balanced)
75 ohms
75 ohms
(unbalanced)
Input level Input
frequency
2 V p-p 44.1 kH
(TTL ±12.5%
level)