Philips SBCRU880/10C Mode D'emploi page 13

4 Press OK.
– The SBC RU880 is in THEATRE set-up mode and the LCD displays ENTER
KEYS.
5 Now press a device key and then the function keys you want to operate that
device with.
For example:
• Press TV
• Press P+, P-, and all of the digit keys
• Press VCR
• Press L, B, G, F
That's it! You have programmed the SBC RU880 to operate both the television
and the VCR in your Home Theatre system. You can programme the SBC RU880
to operate the rest of your Home Theatre devices in the same way, first by first
pressing the device button, and then pressing the function key(s) you want to
operate that device with.
1 When you have finished programming the SBC RU880 in THEATRE mode,
press the SMART key.
– The LCD displays PRESS OK.
2 Press OK to leave THEATRE mode.
4.5 SETTING UP THE SBC RU880 TO TRANSMIT RF CONTROLLED SIGNALS
Philips' Remote Control Extender (SBC LI510) is an innovative wireless extension
system that lets you operate Infra-Red (IR)-driven equipment from anywhere in
your house. The SBC LI510 uses RF technology to convert IR into Radio-
Frequency (RF) signals and back again so they can be used to control your VCR,
satellite receiver or Hi-Fi set regardless of obstacles in between. You can use the
SBC RU880 in combination with a Philips Remote Control Extender set to control
your own devices. And because the SBC RU880 can be set up to transmit Rf
signals, you don't even need the Transmitter section of the LI510 system!
To do this:
1 Press and hold the SMART key (for about three seconds) until the LCD
displays TIMER. Release the SMART key.
2 Press Cursor up or Cursor down until the LCD displays SPECIAL.
3 Press OK.
– The LCD displays THEATRE.
4 Press Cursor up or Cursor down until the LCD displays RF.
5 Press OK.
– The LCD displays RF OFF.
6 Press Cursor up.
– The LCD displays RF ON.
7 Press OK.
– The SBC RU880 returns to normal operation and can transmit both infra-red
and RF signals.
13