Securing The Refrigerator - Dometic GROUP RMD10 Série Instructions De Montage

RMD10
4.5 Installing condensation drain
I
NOTE
• Condensation can form inside the refrigerator due to frequent door
opening, incorrectly stored food or food that is stored when it is too
warm.
• Condensation must be drained with a constant slope.
Install the condensation drain as follows:
Variant 1
➤ Run the condensation hose from the refrigerator through an opening in the floor
which goes outside under the vehicle.
Variant 2
➤ Attach the condensation hose directly to the fitting intended for it on the
ventilation grill (fig. 9 4, page 8).
4.6 Install the roof vent
No. in
fig. c, page 9
1
2
➤ Seal the installation frame to make the connection waterproof (fig. d, page 9).
➤ Insert the installation frame and screw it down tightly (fig. e, page 10). Use all
the fixing holes for this.
➤ Insert the hood and screw it down tightly (fig. f, page 10).
4.7

Securing the refrigerator

A
NOTICE!
Only screw through the receptacles provided, otherwise foamed
components, such as cables, can be damaged.
EN
Description
Hood
Installation frame
Installing the refrigerator
21