Table Des Matières; Important Safety Instructions - Milwaukee LDM 30 Notice Originale

CONTENTS
Important safety instructions ...................................................1
Specified Conditions of Use ...................................................2
Error Code Table ....................................................................2
Overview.................................................................................3
Belt Clip ..................................................................................4
Change batteries ....................................................................4
On/Off .....................................................................................5
Measuring ...............................................................................6
ENGLISH

IMPORTANT SAFETY INSTRUCTIONS

Do not use the product before you have studied
the Safety instructions and the User Manual.
Laser Classification
WARNING:
It is a Class 2 laser product in accordance
with EN60825-1:2014 .
LASER
2
WARNING:
Avoid direct eye exposure. The laser beam can cause flash
blindness.
Do not stare into the laser beam or direct it towards other
people unnecessarily.
Don't dazzle other individuals.
WARNING:
Do not operate the tool around children or allow children to
operate the tool.
The reflective surface could reflect the beam back at the
operator or other persons.
Keep extremities in a safe distance from the moving parts.
Carry out periodic test measurements. Particularly before,
during and after important measurements.
Watch out for erroneous measurements if the product is
defective or if it has been dropped or has been misused or
modified.
WARNING: Use of controls, adjustments, or the performance
of procedures other than those specified in the manual may
result in hazardous radiation exposure.
The laser distance measurer has limits of use. (Refer to the
"Technical data" section). Attempts to measure outside the
maximum and minimum range will cause inaccuracy. Use in
adverse conditions including too hot, too cold, very bright
sunlight, rain, snow, fog, or other vision restricting conditions
will result in inaccurate readings.
When the laser distance measurer is brought into a warm
environment from very cold conditions, or vice versa, allow it to
come to the surrounding temperature before use.
Always store the laser distance measurer indoors, avoid
exposing the tool to shock, continuous vibration or extreme
temperatures.
Always keep the tool away from dust, liquids and high humidity.
These may damage internal components or affect accuracy.
Do not use aggressive cleaning agents or solutions. Use only a
clean, soft cloth for cleaning.
Avoid heavy impact to or dropping of the measuring tool. The
accuracy of the tool should be checked before use if it has
been dropped or subjected to other mechanical stresses.
Any repair required on this laser product should be performed
only by authorised service personnel.
Do not operate the product in explosion hazardous areas or in
aggressive environments.
Flat batteries must not be disposed of with household
waste. Care for the environment and take them to the
collection points provided in accordance with national or
local regulations. The product must not be disposed with
household waste. Dispose of the product appropriately in
accordance with the national regulations in force in your
country. Adhere to the national and country specific regulations.
Please contact your local authority or your dealer for how to
dispose of batteries properly.
European Conformity Mark
1