Sony BC-TRF Mode D'emploi

Battery charger
Chargeur de Batterie
Operating instructions
Mode d'emploi
Owner's Record
The model and serial numbers are located on the bottom.
Record the serial number in the space provided below. Refer
to these numbers whenever you call upon your Sony dealer
regarding this product.
Model No. BC-TRF
Serial No.
BC-TRF
© 2004 Sony Corporation Printed in Japan
•The BC-TRF battery charger can only be used to charge a
lithium ion type "InfoLITHIUM" battery pack (F series).
•This unit cannot be used to charge a nickel cadmium
type or nickel metal hydride type battery pack.
•"InfoLITHIUM" F series battery pack has the
mark.
•"InfoLITHIUM" is a trademark of Sony Corporation.
•Le chargeur de batterie BC-TRF ne peut être utilisé que
pour la recharge de batteries au lithium-ion de type
« InfoLITHIUM » (série F).
•Ce chargeur ne peut pas être utilisé pour charger les
batteries au nickel-cadmium ou aux hydrures
métalliques de nickel.
•Les batteries rechargeables « InfoLITHIUM » de série F
portent la marque .
•« InfoLITHIUM » est une marque de fabrique de Sony
Corporation.
A
1
CHARGE
lamp
CHARGER
V mark
Battery release button
POWER plug
2
B C
Warranty for Recorded Content
Contents of the recording cannot be compensated if recording or
playback is not made due to a malfunction of the battery pack,
battery charger, etc.
English
3-089-567-12(1)
WARNING
To prevent fire or shock hazard, do not expose the unit to
rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
The graphical symbols with supplemental marking is located on
side surface of the unit.
CAUTION
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority to
operate this equipment.
This power unit is intended to be correctly orientated in a
vertical or floor mount position.
NOTE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
Battery pack
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for
help.
BATTERY V mark
Notes on Use
Precautions on Use
• Connect the battery charger to an available wall outlet. Even
though the CHARGE lamp of this battery charger is off, it is
not disconnected from the power source. If any trouble occurs
while the unit is in use, unplug the battery charger from the
wall outlet to disconnect the power source.
• This unit cannot be used to charge a nickel cadmium type, or
nickel metal hydride type battery pack.
• Attach the battery pack to the unit firmly when you charge the
battery pack.
• The battery terminal may be damaged if the battery pack is not
attached correctly.
• To protect the battery pack, remove the battery pack from the
unit within 24 hours after the charging is completed.
• Do not apply mechanical shock or drop the unit.
• Keep the unit away from a TV or AM receivers.
In particular, noise from the device may enter a TV or radio if
it is placed nearby.
• Unplug the unit from the wall outlet after use. Pull the unit out
by the battery charger. Do not pull it out by the battery pack.
• Be sure that nothing metallic comes into contact with the metal
parts of the unit. If it does, a short may occur and the unit may
be damaged.
Where not to place this unit
Regardless of whether this unit is in use or in storage, do not
place it in any of the following locations. Doing so may lead to
breakdown.
• Locations of extremely high temperature
The temperature gets extremely high inside a car with the
windows closed in summer or in strong sunshine, and leaving
the unit inside may cause it to be deformed or break down.
• In direct sunlight or near a heater
There is a risk of deformation or breakdown.
• Locations of excessive vibration
• Locations with strong electromagnetism or radiant rays
• Locations with excessive sand
In locations such as the seashore and other sandy areas or
where dust clouds occur, protect the unit from sand and dust.
There is a risk of breakdown.
Maintenance
• Wipe the unit with a soft dry cloth when it is dirty.
• If the unit is very dirty, wipe it using a cloth with a little
neutral solvent added, and then wipe it dry again.
This symbol is intended to alert the user to the
presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
• Do not use thinners, benzine, alcohol, etc., as they will damage
the surface of the unit.
• When you use chemical cleaning clothes, refer to their
instruction manual.
• Using a volatile solvent like an insecticide, or keeping the unit
touching a rubber or vinyl plastic product for a long time may
cause a deterioration or damage to the unit.
To Charge the Battery Pack
Charging by attaching the battery pack to this unit.
1 Attach the battery pack. (See Illustration A)
Align the battery V mark in the direction of the charger V
mark and insert it in the direction of the arrow. (See
Illustration A-1)
After inserting it as far as it will go, press lightly in the
direction of the arrow until it clicks. (See Illustration A-2)
2 Pull the power plug up, and then connect it to a wall
outlet. (See Illustration B)
The CHARGE lamp (orange) will light up and charging will
begin.
When the CHARGE lamp goes out, normal charging is
completed (Normal charge).
For a full charge, which allows you to use the battery longer
than usual, leave the battery pack in place for approximately
another one hour (Full charge).
Do not connect the power plug of this unit with the prong of
the plug at the bottom. (See Illustration C )
To remove the battery pack
Push the battery release button V forward and remove the
battery.
Charging time
The following table shows the charging time for a battery pack
that is discharged completely.
Battery Pack NP-FF50 NP-FF51 NP-FF70 NP-FF71
Full charging time 185 200
Normal charging time
(125) (140)
• Approximate number of minutes to fully charge an empty
battery pack (Full charging time).
• Numbers in parentheses indicate the time to charge normally
(Normal charging time).
• To ascertain the battery life, refer to the instruction manual of
the digital still camera that you use.
• The charging time may differ depending on the condition of
the battery pack or the temperature of the environment.
Charging temperature
The temperature range for charging is 0 °C to +40 °C (+32 °F
to +104 °F). However, to provide maximum battery
efficiency, the recommended temperature range when
charging is +10 °C to +30 °C (+50 °F to +86 °F).
To use the battery pack quickly
You can remove the battery pack from the unit and use it even
though the charging is not completed yet. However, the time
that the battery pack can be used differs depending on the
charging time.
Notes
• Check if the battery pack is attached to this unit firmly when
the CHARGE lamp does not light.
• When a fully charged battery pack is installed, the CHARGE
lamp will light up once, then go out.
• When charging a battery pack which has not been used for a
long time, it may take longer than usual to charge.
Do not connect the battery charger to a voltage adaptor
(travel converter) for overseas travel. This may result in
overheating or other malfunction.
Troubleshooting
When the CHARGE lamp blinks, check through the following
chart.
Remove the battery that is being charged and firmly attach the same
battery again.
The CHARGE lamp blinks again: The CHARGE lamp lights up
Install another battery pack. and does not blink again:
If the CHARGE lamp goes out
because the charging time has
passed, there is no problem.
The CHARGE lamp blinks again: The CHARGE lamp lights up
The problem is with this unit. and does not blink again:
If the CHARGE lamp goes out
because the charging time has
passed, the problem is with the
battery pack first installed.
Please contact your nearest Sony dealer in connection with the product
with the problem.
Specifications
Input rating 100 - 240 V AC 50/60 Hz 5 W
Output rating Battery charge terminal:
8.4 V DC 350 mA
Operating temperature 0 °C to +40 °C (+32 °F to +104 °F)
Storage temperature –20 °C to +60 °C (–4 °F to +140 °F)
Approx. 57 × 34 × 70 mm (w/h/d)
Dimensions
× 1 × 2
(2 1 / 3 /
4 8
Mass Approx. 70 g (2.5 oz)
Design and specifications are subject to change without notice.
310 340
(250) (280)
7 / inches)
8