Kokido Telsa 90 Manuel D'utilisation page 14

To effectively vacuum up debris, ensure the pool vacuum is laid flat on the pool floor
as you steer it back and forth in regular motion over debris patches for collection.
Debris is collected from the front, side and back to fill up the filter bag.
Excess dirt and debris in the pool could clog the impeller, which would automatically
stop to protect the motor, and the indicator light would turn red. Remove the vacuum
from the pool and turn it off prior to unclogging and emptying the filter bag if it is full.
To resume operation, turn the switching knob anticlockwise until Power Off is selected,
then turn it clockwise to select Power On.
2) To retrieve the pool vacuum, bring it poolside and flip it upside down before lifting.
This is done to prevent debris from scattering back into the pool (especially if you
are using the fine filter bag) and avoid bending the pole in the process.
Once the pool vacuum is out of the water, the impeller will cease to spin within 2-3
seconds. The LED light will turn blue. When battery level is running low, blue light will
flash.
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any
aggressive detergent.
4) Dry the charging port and pins thoroughly (TIPS: Use cotton bud to dry them)
Light Color
Blue Power On
(ready for operation)
Blue – Flash Battery level is running low
Green In operation
Green -Flash Battery level is running low.
Green light Off Battery depleted
(need to be recharged)
Red Impeller stops
(impeller clogged).
13