Cleaning And Maintenance - senya SYBF-CJ018R/C Notice D'utilisation

The juicer The filter and the pressing
stops while screw are clogged
working The food is cut in too big
normally pieces
The juicer is too full or
overheated due to an
excessive amount of fruit or
vegetables
The juice The anti-drip spout is
does not closed
come out
The seal of the spout for
the pulp is not positioned
correctly
Le joint du bec verseur de
pulpe n'est pas mis
correctement

6. Cleaning and maintenance

Always ensure that the juicer is turned off and the power cord is unplugged
before cleaning.
1. Immediately after each use, use the cleaning brush to thoroughly clean
the fine holes of the filter. If the holes are clogged, soak the filter in
warm water with 10% lemon juice to loosen the blocked holes.
If the filter cannot be cleaned immediately after use, soak it in hot soapy
water immediately after juicing. If the pulp residue dries on the filter, it
can clog the mesh holes, thus reducing the efficiency of the juicer. Do not
soak the filter in bleach.
2. Wash the detachable parts in warm soapy water with the cleaning brush
or a soft cloth. Rinse and dry them thoroughly.
3. Wipe the base of the motor with a soft, damp cloth and dry it
thoroughly. Do not use scouring pads or abrasive cleaners when cleaning
the base of the product as they may scratch or damage the surface.
Do not attempt to force the cover
open
Turn off the device, unplug it and
remove the cover. Remove the
food if necessary and continue
juicing.
Turn off the device, unplug it and
disassemble it. Clean it, then
reassemble the juicer.
Allow to cool for about 30
minutes before restarting it.
Open the anti-drip spout
Put the seal back in correctly and
check that it is pushed down
properly
Remettez correctement le joint et
vérifiez qu'il soit bien enfoncé