Disassembling The Juicer; Troubleshooting Guide - senya SYBF-CJ018R/C Notice D'utilisation

1. Remove all hard and inedible skins (the skin of melons, pineapples,
mangos, etc.) before juicing.
2. Ensure that the device is properly locked.
3. Position the pulp collecting container under the spout for the pulp and
position the juice collecting container under the spout for the juice.
4. Connect the device and turn the switch to the "on" position (the on/off
button must be facing upwards). Place the pre-cut pieces in the feed
chute and gently press with the push-button until all the fruits and
vegetables pass into the juicer.
5. The juice will flow directly into the appropriate container, as will the
pulp.
6. After use, set the switch to "off" (the on/off button must be positioned
in the middle). Disconnect the device and then disassemble it.
Note: Do not put your fingers or any other objects into the feed chute during
operation

5.4 Disassembling the juicer

1. Ensure that the juicer is off and the power cord is unplugged from the
power socket
2. Remove the juice container and the pulp container
3. Remove the feeding tube by turning it anti-clockwise
4. Remove the pressing screw and the filter
5. Remove the juicer bowl

Troubleshooting guide

Problem Cause
The juicer The juicer is not plugged in
does not The detachable parts are
work/start not properly assembled on
the base of the product or
the feeding tube is not
properly locked
The feeding The pressing screw is not
tube cannot inserted correctly
be installed The filter is not properly
attached to the juicer bowl
Solution
Check that the device is plugged
in properly
Check that all the parts are
assembled correctly
Check that the pressing screw is
pushed right to the end and
positioned correctly. Check that
the filter is installed correctly