Positioning The Logs - Dru Colourline Mode D'emploi

INSTRUCTIONS FOR INSTALLATION
Mounting the front panel Concerto (fig. 9a)
The coloured or stainless steel frame (A) is packed sepa-
rately from the basic set.The frame is fitted to the front
panel (B) using the 8 bolts supplied (C). Make sure that the
tall edge is at the bottom.
Hohe Rand
fig. 9a

Positioning the logs

Position the logs as follows:
• Lay the large log against the back wall, on the log sup-
ports.
• Fill the burner with vermiculite (this is in the plastic bag
with the log set).
• Spread it evenly over the burner tray and the surrounding
tray.
• Take the black and yellow chips from their bags and spread
them equally over the tray surrounding the burner.
• Do not place any chips on the burner tray.
• Make sure that no vermiculite gets on or into the pilot
light burner, as this could prevent it from working
properly.
• Now lay the rest of the logs in place as illustrated in fig. 5.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs touch
pilot light burner.
You can "play" with the flames by moving the vermiculite,
embers and chips about on the burner bed until you have
created the desired flame effect.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been manu-
factured specifically for this appliance.
fig. 5
14