Genesis GDP805P Manuel D'utilisation page 8

INSTALLING CHUCK, HEAD ASSEMBLY
AND FEED HANDLES (FIG 4)
1. Place the head assembly upside down on a level, flat surface.
2. Position chuck (4) on spindle. Chuck should be fully opened to
avoid damaging jaws.
3. using a piece of scrap wood to protect the chuck, firmly tap the
chuck into place using a mallet or hammer.
4. Position the head assembly onto the column (8) with the chuck
positioned over the table (7).
5. Slide the head assembly down as far as it will go. Align the
direction of the drill press head with the direction of the table
and the base, then tighten the two head set screws (A7) with the
Allen wrench provided.
6. Attach the three feed handles (10) by screwing them into the
threaded holes in the hub (A9).
MOUNTING THE DRILL PRESS
If the drill press is to be used in a permanent location, secure it to
a workbench or other stable surface by inserting the appropriate
mounting hardware through the two predrilled holes in the base.
If the drill press is to be used as a portable tool, fasten it permanently
to a mounting board that can easily be clamped to a workbench or
other stable surface. The mounting board should be of sufficient
size to avoid tipping while drill press is in use. Any good grade
plywood or chipboard with a 3/4" thickness is recommended.
ADJUSTMENTS
WArNING:
is switched off and unplugged from the power
source before adjusting, adding accessories, or
checking a function on the tool.
ADJUSTING SPEEDS AND BELT TENSION
(FIG 5, 6,7)
1. Open the drill press pulley cover (1).
2. Loosen the belt tension knobs (11) on the right side of the drill
press head.
3. Pull the motor (2) toward the drill press head.
4. Set the belt (14) on the desired steps of the motor (12) and
spindle (13) pulleys according to the belt positions on the
Spindle Speed Chart (fIG 7).
5. Push the motor away from the drill press head to increase the
belt tension. Tighten the tension knob (11).
6. The belt (14) should be tight enough to prevent slippage. Correct
tension is set if the belt flexes about 1/2" when thumb pressure
is applied at the midpoint of the belt between the pulleys.
ADJUSTING TABLE HEIGHT (FIG 8)
1. Loosen the table lock handle (6).
2. Slide the table assembly (7) to the desired height.
3. Tighten the lock handle before drilling.
8" 5-Speed Drill Press
Operator's Manual
Always be sure that the tool
A9
4
7
FIG 4
1
FIG 5 13
1
FIG 7
GDP805P
A7
10
8
14 12
11
2
FIG 6