Refilling The Soap - Toto TES100DA Manuel D'installation Et D'utilisation

The soap dispenser keeps track of soap usage by counting
soap dispenses.
It displays a flashing green LED indicator light to signal low
soap level.
A power interruption (AC type) or changing batteries (DC type)
disrupts the count and could prevent the indicator light from flashing.
To ensure accuracy, always add soap to the MAX line once
power is restored.
1. Open the cover.
2. Remove the tank from the controller.
3. Remove pump unit from the tank.
4. Slowly pour liquid soap into the tank.
NOTE: Clean container before refilling.
NOTE: Fill the tank up to MAX fill line.
NOTE: Use only TOTO approved liquid soap.
5. Replace the pump by pushing it down firmly
over the tank opening until it snaps in place.
6. Mount the tank to the controller.
7. Close the cover.
8. Purge the line by holding hands
under spout until soap is discharged.
Dispenser can be actuated up to
ten times consecutively while
holding hands under the spout
immediately after refilling.

REFILLING THE SOAP

Tank
11
Pump unit
Cover
Controller
Cover
Tank
Liquid soap
MAX fill line
Tank
Pump unit
Bottom of Pump