Bluetooth ® Pairing; Manual Station Search - Hama 00014164 Mode D'emploi

Note
• For some vehicle types, the ignition has to be switched on to
supply power to the 12 V car socket. For more information,
please refer to your vehicle's operating instructions.
• Disconnect all cable and on-board connections after use.
6.1 Bluetooth
pairing
®
Note
• Check whether your mobile device (MP3 player, mobile
phone, etc.) is Bluetooth
• If not, the only way you can use the FM transmitter for
playback is with a USB stick or microSD card.
• Note that the maximum range for Bluetooth
without obstacles such as walls, people, etc.
• Make sure that your Bluetooth
and Bluetooth
is activated.
®
• Plug the FM transmitter into a car socket located near the
car radio.
• Make sure that the FM transmitter is within the maximum
Bluetooth range of 10 metres.
®
• Open the Bluetooth
settings on your terminal device and wait
®
until BT21M appears in the list of Bluetooth
• Select BT21M and wait until the FM transmitter is listed as
connected in the Bluetooth
transmission frequency is now shown on the display.
Note – Bluetooth
password
®
Some terminal devices require a password in order to connect to
another Bluetooth device.
®
• If your terminal device requests a password for connection to
the speaker, enter 0000.
Note – Connection impaired
After the FM transmitter and terminal device have been paired,
a connection is established automatically. If the Bluetooth
connection is not established automatically, check the following:
• Check the Bluetooth
®
whether BT21M is connected. If not, repeat the steps listed
under Bluetooth pairing.
®
• Check whether your terminal device and the FM transmitter
are less than 10 metres apart. If not, move the devices
closer together.
• Check whether obstacles are impairing the range. If so, move
the devices closer together.
capable.
®
is 10 metres
®
capable terminal device is on
®
devices found.
®
settings on your terminal device. A
®
settings of your terminal device to see
6.2 Audio playback (via Bluetooth
Start and control audio playback on the connected terminal device
accordingly. Alternatively, audio playback can also be controlled on
the FM transmitter (if the connected device supports this function).
• Press the
>
• Press the
<
• Press the
6.3 Audio playback
(via USB stick or microSD card)
• Plug the USB stick into the USB socket marked with
playback will start automatically.
• Insert a microSD card into the card slot (6) on the FM transmit-
ter; playback will start automatically.
Note
• The capacity of the USB stick or microSD card must not
exceed 32 GB.
• The following formats are supported for audio playback:
MP3.

6.4 Manual station search

• Search for an available frequency on your car radio (static
without partial signals).
• Set the same frequency on the FM transmitter. To do this, press
and hold the
indicator on the display (3) begins to flash.
• Then press the
• The FM transmitter always stores the last frequency set.
Note – Automatic standby
• After 50 to 60 seconds without a music signal or button
being pressed, the FM transmitter switches to standby.
• If it receives a music signal or a button is pressed, the FM
transmitter is activated again.
®
)
®
function button to start or pause audio playback.
function button to jump forward one title.
function button to jump backward one title.
button (5) for 2 seconds until the frequency
< >
or button to set the desired frequency.
(2);
3