Warning - Batteries; Getting Started; Setting The Time Manually - Hama RC40 Mode D'emploi

• Do not place the product near interference fields, metal frames, computers, TVs, etc. Electronic devices and
window frames can negatively affect the product's functionality.
• Do not drop the product and do not expose it to any major shocks.
• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep the packaging material out of the reach of children due to the risk of suffocation.
• Dispose of packaging material immediately according to locally applicable regulations.
Warning – Batteries
• Immediately remove and dispose of dead batteries from the product.
• Only use batteries (or rechargeable batteries) that match the specified type.
• When inserting batteries, note the correct polarity (+ and - markings) and insert the batteries
accordingly. Failure to do so could result in the batteries leaking or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and keep them away from uncoated metal
objects.

4. Getting Started

Open the battery compartment, remove the contact breaker and then close the battery compartment.
5. Operation
5.1. Automatic time setting using the DCF signal
• After the contact breaker is removed, the display is switched on and an acoustic signal sounds for 2
seconds. The clock automatically searches for the radio signal. This process can take 3 to 5 minutes.
• When the radio signal is received, the date and time are automatically set and the radio-controlled clock
icon is displayed. The clock automatically receives the time code every hour.
• If the clock is unable to receive a time signal wirelessly, the time/temperature are displayed and the icon
is not visible. In this case, you can set the time manually.

5.2. Setting the time manually

Press and hold MODE for 2 seconds in the time and calendar display to set the system date and time.
• Press the MODE button again:
The digits of the year flash. You can set the year with the + and – buttons.
• Press the MODE button again:
The digits of the month flash. You can set the month with the + and – buttons.
• Press the MODE button again:
The digits of the date flash. You can set the date with the + and – buttons.
3