Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
AUTOMATIC OPERATION
Use this function if the oven is to be switched on for a specified period of time and switched off
at a fixed hour.
Set the preparation time and the end time.
Example: the current time is 11:00. The cooking time is 1 hour. The dish has to be done by 14:00.
The oven starts cooking at 13:00 (14:00 minus 1 hour) on the preset temperature and oven
function and will finish at 14:00.
• Press the [ OK ] key until the display shows dur and the
• Set the required preparation time using the keys [ < ] or [ > ].
• Press the [ OK ] key repeatedly until the display shows End and the
• Set the switch off time (preparation end time) using the keys [ < ] or [ > ]. The end time is
limited to a period of 23 hours and 59 minutes.
• Set the oven function knob and the temperature knob to the setting at which you want the
oven to operate. Both symbols
• Once the preparation time has elapsed the oven will turn off automatically. You will hear an
alarm and the symbols
• Press and hold any key to mute the alarm. The symbols
will show the current time after approximately 7 seconds - i.e. 14:02.
• Turn the knobs for the oven function and the temperature to the off setting [ 0 / ].
CANCEL SETTINGS
The timer and the automatic function settings may be cancelled at any time.
• Press the keys [ < ] and [ > ] simultaneously to cancel the automatic function settings.
• Press the [ OK ] key to select the timer settings and then press the keys [ < ] and [ > ] simultaneously to cancel the timer.
CHANGE THE TONE OF THE ALARM SIGNAL
The tone of the alarm signal may be changed as follows:
• Press the keys [ < ] and [ > ] simultaneously.
• Select with the [ OK ] key the function ton. The display will flash.
• Select with the key [ > ] the desired tone in the following order: ton 1, ton 2 or ton 3
or
• select with the key [ < ] the desired tone in the reverse order: ton 3, ton 2 or ton 1.
ADJUSTING THE BRIGHTNESS OF THE DISPLAY
You can adjust the brightness of the display in the range of 1 to 9, where 1 is the darkest and 9 is
the brightest. The brightness setting applies to an inactive control panel, i.e. when none of the
controls are used 7 seconds.
• Press the keys [ < ] and [ > ] simultaneously.
• Press the [ OK ] key repeatedly to select the bri setting. The settings can be accessed in
sequence ton (tone) and bri (brightness).
• Select the desired brightness with the key [ > ] in the following order: 1 to 9
or
• select the desired brightness with the key [ < ] in the reverse order: 9 to 1.
Note: The display is at its brightest setting when active, i.e. a control was touched within the last 7 seconds.
NIGHT MODE
The display is dimmed during the night hours: 22:00 - 6:00.
34
•
English
and
are now active. Automatic operation has been set
and
will be flashing.
symbol flashes.
symbol flashes.
and
will be off and the display
OK
OK
OK
OK
OK
OK
Publicité
Table des Matières
