Speed Regulator; Assembly - Operating As Volume Pump; Assembly - Extracting Clean Air; Maintenance And Cleaning - Batavia MAXXPACK BT-CB002 Mode D'emploi

one-hand operation. The device can be
operated with the right or the left hand.
• Angle the device forwards slightly, and
walk forwards slowly.
• Sweep the machine to the right and left
in order to blow away the leaves.
• Never work against the wind to ensure
that you and persons behind you are
not soiled.
• Always make sure to have a safe stand
while working with the device.
• Do not overload the device during work.
Do not block the blower outlet and the
suction inlet while working with the
device.
• Make sure long hair or loose clothing
cannot get into the openings of the
device.
• In dusty locations, it is advisable to
slightly dampen the surface with a
suitable spraying device to avoid too
much dust.
• In case of stubborn soiling, it is
advisable to loosen the surface with a
rake or broom.
• After operation, remove the battery
from the device to avoid unintentional
switching on.

9. Speed regulator

The device is equipped with an infinitely
adjustable speed regulator (5).
When starting work, adjust the speed
9.1
regulator to the lowest setting for low
air volume.
Turn the speed regulator in direction to
9.2
the highest setting, according to the
desired application.
10. Assembly – Operating as volume
pump
To inflate water toys (e.g. water balls),
10.1
mount the nozzle holder (9) on the
blower outlet (3) of the device.
Insert the suitable nozzle (10) into the
10.2
nozzle holder (9).
Make sure the nozzle holder is properly
10.3
locked in the blower opening.
• Do not leave the inflating object
unattended!
• The device does not switch off
automatically. Thus the object to be
inflated can burst.
11. Assembly – Extracting clean air
For extracting clean air from an object,
11.1
e.g. from an inflated airbed, mount the
suitable nozzle (10) on the suction inlet
(8) and switch on the device.
Do not leave the device unattended
11.2
during work.

12. Maintenance and cleaning

WARNING: Always disconnect from the
mains power supply, before carrying out any
maintenance/ cleaning of the charger.
Remove the battery before carrying out any
maintenance/ cleaning of the tool.
Maintenance
12.1
There are no inner parts of the tool which
need maintenance.
Cleaning
12.2
• Keep safety devices, ventilation
openings and the motor housing as free
as possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure
compressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap.
Do not use any cleaning or solvent
materials; these can attack the device's
plastic components. Make sure that no
water can get inside the electric power tool.

13. Storing

• Clean the device before storing it.
• Before storing check all parts for
damages.
• Store the device indoors in dry place
that is protected from dust and dirt and
extreme temperatures.
English
9