• Always make sure to have a safe stand
while working with the device.
• Do not overload the device during work.
Do not block the blower outlet and the
suction inlet while working with the
device.
• Make sure long hair or loose clothing
cannot get into the openings of the
device.
• In dusty locations, it is advisable to
slightly dampen the surface with a
suitable spraying device to avoid too
much dust.
• In case of stubborn soiling, it is advisa-
ble to loosen the surface with a rake or
broom.
• After operation, remove the battery
from the device to avoid unintentional
switching on.
9. LED
• To switch on the LED, press the button
(8) once.
• To switch off the LED, press the button
again.
10. Turnable handle
The handle can be locked in 2 working
positions.
To avoid unintentional operation, of the
device, remove the battery!
To adjust the working position of the
10.1
handle, slide the handle unlock button
(4) forwards and simultaneously turn
the blower to the side.
Turn the handle until you hear a click
10.2
sound and the handle is properly locked
in this position.
11. Speed regulator
The device is equipped with an infinitely
adjustable speed regulator (6).
When starting work, adjust the speed
11.1
regulator to the lowest setting for low
air volume.
Turn the speed regulator in direction to
11.2
the highest setting 7, according to the
desired application.
12. Assembly – Operating as vol-
ume pump
To inflate water toys (e.g. water balls),
12.1
mount the nozzle holder (10) on the
blower outlet (3) of the device.
Insert the suitable nozzle (11) into the
12.2
nozzle holder (10).
Make sure the nozzle holder is properly
12.3
locked in the blower opening.
• Do not leave the inflating object
unattended!
• The device does not switch off auto-
matically. Thus the object to be inflated
can burst.
13. Assembly – Extracting clean air
For extracting clean air from an object,
13.1
e.g. from an inflated airbed, mount the
suitable nozzle (11) on the suction inlet
(9) and switch on the device.
Do not leave the device unattended
13.2
during work.
14. Maintenance and cleaning
WARNING: Always disconnect from the
mains power supply, before carrying out any
maintenance/ cleaning of the charger.
Remove the battery before carrying out any
maintenance/ cleaning of the tool.
Maintenance
14.1
There are no inner parts of the tool which
need maintenance.
Cleaning
14.2
• Keep safety devices, ventilation open-
ings and the motor housing as free as
possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure com-
pressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap.
Do not use any cleaning or solvent materi-
als; these can attack the device's plastic
components. Make sure that no water can
get inside the electric power tool.
English
7