SETTING UP YOUR OVEN
Names of Oven Parts and Accessories
Remove the oven and all materials from the carton and oven cavity.
Your oven comes with the following accessories:
•
Glass tray
•
Turntable ring assembly
•
Instruction Manual
Oven parts
1. Control panel
2. Turntable shaft
3. Turntable ring assembly
4. Glass tray
5. Observation window
6. Door assembly
7. Safety interlock system
7
6
5
4
3
2
TURNTABLE INSTALLATION
Installation and connection
•
•
•
•
•
•
•
•
Grill Rack( Only for Grill series )
1
•
The accessible surface may be hot during operation.
OPERATION INSTRUCTION
This microwave oven uses modern electronic control to adjust cooking
parameters to meet your needs better for cooking.
1. Clock Setting
When the microwave oven is electrified, the oven will display "0:00", buzzer
will ring once.
Remove all packing material and accessories. Examine the oven for any
damage such as dents or a broken door. Do not install if the oven is damaged.
Remove any protective film, found on the microwave oven cabinet surface.
Do not remove the light brown Mica cover that is attached to the oven
cavity to protect the magnetron.
Select a level surface that provide enough open space for the intake
and/or outlet vents.
The rear surface of appliance shall be placed against a wall. A minimum
clearance of 7.5cm is required between the oven and any adjacent
walls. One side must be open. Leave a minimum clearance of 30cm
above the oven. Do not remove the feet from the bottom of the oven.
Blocking the intake and/or outlet openings can damage the oven.
Place the oven as far away from radios and TV as possible. Operation of
microwave oven may cause interference to your radio or TV reception.
Plug your oven into a standard household outlet. Be sure the voltage
and the frequency is the same as the voltage and the frequency on the
rating label.
Do not install the oven over a stove or other heat-producing appliance.
If installed near or over a heat source, the oven could be damaged and
the warranty would be void.
Microwave-grill
EN
7