Publicité
Les langues disponibles
Les langues disponibles
No.
Tones
1
Continuous Tone 800/970Hz at 1Hz
2
Continuous Tone 970Hz
II. INSTALLATION.
A. Unpacking.
After unpacking the sounder, examine it for damage that may have occurred in transit. If equip-
ment has been damaged, do not attempt to install or operate it. File a claim immediately with
the carrier stating the extent of the damage. Carefully check all envelopes, shipping labels and
tags before removing or destroying them.
B. Mounting Arrangements.
To access mounting holes and electrical connections turn over the LP7 so the strobe lens is fac-
ing down. Twist the base counter-clockwise to remove.
The base of the LP7 provides six (6) slotted recesses for mounting, and one (1) 15/32" cable
access hole.
C. Electrical Connections.
To avoid electrical shock, do not attempt to connect wires when power is on.
A terminal block is supplied on the LP7 for field wiring. Strip 1/2" of insulation from the wir-
ing leads. Attach the appropriate wires to the corresponding terminals. Tighten the screws to
insure that the wires are firmly held in place. The terminals will accept conductor sizes
23 AWG to 13 AWG .
III. TESTING/OPERATING.
Under certain conditions these devices are capable of producing sound loud enough to cause
hearing damage. Adequate hearing protection should be worn if standing within close proximity to
the device while testing. Recommendations in OSHA Sound Level Standard (29CFR 1910)
After completion of installation be sure to test the system to verify that each sounder unit
operates satisfactory.
After completion of initial system test, a program for periodic testing of this device should
be established.
Provide a copy of these instructions for the Safety Engineer(s), System Operators(s) and Mainte-
nance personnel.
Although your warning system is operating properly it may not be completely effective.
People may not hear or heed your warning signal. You must recognize this fact and ensure that your
warning signal achieves its intended effect through proper test/training sequences
Table 1.
DANGER
WARNING
should not be exceeded.
SAFETY MESSAGE TO OPERATORS
suitable for your specific application(s).
-2-
Typical
Output
(dB at 1 M)
101
101
Publicité
