Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION AND SERVICE INSTRUCTIONS FOR STREAMLINE
People's lives depend on your safe installation of our products. It is important to read, understand
and follow all instructions shipped with this product.
Selection of mounting location for this device, its controls and routing of wiring should be made
by the Facilities Engineer and the Safety Engineer. Listed below are other important safety
instructions and precautions you should follow.
• This unit must be installed and maintained by a qualified electrician in accordance with National
and local Electrical Codes, under the direction of the authority having jurisdiction.
• Do not connect this unit to system wiring when circuits are energized.
• For optimum sound distribution do not install this device where objects would block the front
of the sounder.
• All effective warning horns produce loud sounds which, in certain circumstances, may cause per-
manent hearing loss. Take appropriate precautions such as wearing hearing protection. Recom-
mendations in OSHA Sound Level Standard (29 CFR 1910) should not exceeded.
• After installation, be sure that all threaded joint are securely tightened.
• After installation and completion of initial systems test, a program for periodic testing of
this device must be established.
• After installation and completion of initial system test, provide a copy of this instruction sheet to
all personnel responsible for operation, periodic testing and maintenance of this equipment.
I. GENERAL.
The Federal Model LP7 sounder/strobe provides an audible and visual signal when activated re-
motely. The sounder is a polarized device rated at 18–30VDC. The LP7 can provide two
different tones with an adjustable volume, located on the inside of the unit. The LP7 can provide a
Sweeping tone or a Continious tone. See table 1.
Electrical Details:
Termination:
Voltage Range:
Starting Current:
Running Current:
Monitoring:
Mechanical Details:
Diameter:
Overall Depth:
IP Rating:
Temp. range:
Material:
LP7 SOUNDER/FLASHER
SAFETY MESSAGE TO INSTALLERS
Screw terminals for 23 AWG to 13 AWG conductors.
18–30VDC
1.1 A for 1 mSec.
68mA average
Polarizing Diode
3.66" [93 mm]
Shallow Base: 3.6" [92mm]
IP54
-40°F to 176°F (-40°C to 80°C)
ABS Plastic Body with Polycarbonate Lens
-1-
Deep Base: 4.13" [105mm]
Publicité
