Siemens GS D Série Mode D'emploi page 42

en
Fault
Warning signal
sounds, Alarm display
lights up.
The freezer
compartment is too
warm! Frozen food
is at risk!
Freezer compartment
door was open
for a long time;
temperature is no
longer reached.
Appliance is not
cooling, temperature
display and light
are lit.
42
Possible cause
Appliance is open.
Ventilation openings
have been covered.
Too much food was
placed in the freezer
compartment at once.
The evaporator
(refrigeration
generator)
in the NoFrost system
is covered in thick ice
and can no
longer be defrosted
fully automatically.
Showroom mode is
switched on.
Remedial action
To switch off the warning signal,
press the Alarm button. Fig. 2/5
Close the appliance.
Ensure that there is adequate
ventilation.
Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the Alarm display goes out shortly
afterwards.
To defrost the evaporator, remove
the frozen food
with the compartments, insulate well
and store in a cool location.
Switch off the appliance and move
it away from the wall. Leave
the appliance door open.
After approx. 20 min.
the condensation begins to run
into the evaporation pan,
at the rear of the appliance. Fig. 7
To prevent the evaporation pan
from overflowing in this case,
mop up the condensation
with a sponge.
The evaporator is defrosted when
the water stops running
into the evaporation pan. Clean
the interior. Switch the appliance
back on again.
Hold down alarm button, Fig 2/5,
for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.