After Operation - Prematic AIRSTAR 45 Notice Originale

! [ ]

After operation

After operation or long break in operation proceed as follows.
To disconnect from compressed air supply proceed as follows:
Switch off the compressor using the switch (1).
Disconnect the compressor from power supply.
Disconnect connected pressure hose from the quick-split coupling.
Proceed as follows:
Press union nipple of pressure hose to the quick-split coupling
Move the external O-ring of quick-split coupling backwards
Quick-split connection is unlocked.
Remove pressure hose from the quick-split coupling.
In this case you will hear leftover compressed air in the edge device goes out.
Drain the remaining compressed air from receiver through the drain valve.
14
Überschrift 1
DANGER
In case of opening of union nipple a freely suspended pressure hose can cause
severe or fatal injuries.
Secure firmly pressure hose.