Medisana IN 500 Mode D'emploi page 27

Masquer les pouces Voir aussi pour IN 500:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35
3.1
Preparing
for
Clean and disinfect the nebulizer kit as described under "4.1
inhalation
Cleaning and maintenance" in order to avoid a possible infection
by contaminated parts!
Additionally general hygiene regulations (e.g. thoroughly washing
the hands, hygienic handling of the medication) must be observed.
Before starting therapy, discuss the length, dosage and frequency
of use with your doctor. The method of use should be appropriate
to the aim of the therapy (e.g. lung treatment = use of mouthpiece
and treatment of the nasal-pharyngeal area = use of mask).
Consult your doctor about this aspect as well.
1.
2.
3.
4.
5a.
5b.
- Make sure that all parts are firmly connected to each other.
The air tube needs to be securely attached to the compressor
(main unit) and nebulizer kit.
- Take care not to spill any medication.
- Use the nebulizer kit holder
nebulizer kit.
WARNING
NOTE
Rotate the inhalation top
nebulizer tank
.
Place the vaporizer head
Fill in the correct amount (min. 2 ml and max. 10 ml) of prescribed
medication into the nebulizer tank
pour all the liquid out and clean the nebulizer kit as described
under point "4.1 Cleaning and maintenance".
Rotate the inhalation top
tank
.
Plug either the mouthpiece
connection tube for mouthpiece and nose adaptor
top. Therefore the connection tube
on the upper part of the inhalation top with the longer end. Then the
mouthpiece
or the nose adaptor (
to the shorter end of the connection tube
Alternatively, you may use the adult or child mask (
inhalation. Therefore you need the mask connection tube instead of the
connection tube
. Make sure, the power switch
Connect the power plug to the mains outlet and place one end of the
air tube
firmly over the connection for air tube
sor. Place the other end over the appropriate connection for air tube
of the nebulizer kit.
NOTES
counterclockwise to remove it from the
on the nozzle
.
. If you have overfilled the tank
clockwise to properly fix it on the nebulizer
, or a nose adaptor (
needs to be put onto the nozzle
or
.
as a temporary holder for the
3 Operating
or
) with the
onto the inhalation
) needs to be connected
or
) for the
is turned off ("O").
of the compres-
GB
g
g
g
g
g
f
19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

In 5505452054530

Table des Matières