Hex Wrench Storage - Makita 5402NA Manuel D'instruction

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Removing or installing saw blade
2
001969
CAUTION:
Be sure the blade is installed with teeth pointing up
•
at the front of the tool.
Use only the Makita wrench to install or remove the
•
blade.
Release the lock lever of blade steady device.
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
1 2
001970
After installing the blade, lock the lock lever.
When changing blade, make sure to also clean the
upper and lower blade guards of accumulated sawdust
as discussed in the Maintenance section. Such efforts
do not replace the need to check lower guard operation
before each use.
CAUTION:
The inner flange has a 25 mm (63/64") diameter on
•
one side and a 25.4 mm (1") diameter on the other.
The side with 25.4 mm (1") diameter is marked by
"25.4".
Use the correct side for the hole diameter of the
blade you intend to use. Mounting the blade on the
wrong side can result in dangerous vibration.
1. Shaft lock
1
2. Hex wrench
1. Hex bolt
2. Outer flange
3. Inner flange
4. Saw blade
3
4
1
25.4
1. Mounting shaft
2. Inner flange
3. Outer flange
4. Hex bolt
5. Blade
001971

Hex wrench storage

2
001972
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
To remove the hex wrench, push the shorter side of it out
with your finger. Then remove the hex wrench.
001973
To store the hex wrench, insert the longer side of it into
the lever. Then push the shorter side of it down.
2
1
001974
8
2 3 4
25 25
5
1. Lever
2. Hex wrench
1