Advanced Parameter Setting For Remote Control - Zehnder 40019309 Notice D'utilisation

5.3 Advanced parameter setting for remote control

WARNING"
Access to parameter setting is possible only when the remote control is off.
Some parameters on your remote control can be adjusted according to how you use it.
2
seconds
boost boos
mode mode
Parameter
number
boost
previous
mode mode
parameter.
No Parameter Description
Duration Adjustable from 15 to 120 minutes in 15 minute steps
0
of Boost
operation
Window Value 0 (function disabled) or 1 (function enabled)
1
open
detection
Eco Value 0 (eco temperature unlinked) or 1 (linked eco-
2
temperature temperature setting: comfort T° minus 3.5°)
64
Press on P1P2 and
mode for 2 seconds
to enter.
Parameter
value
WARNING
It is essential to get
Go to
changes.
the next
parameter.
Default Setting
setting
60 Press the
1
Press the
1
Press the
No Parameter Description
Pilot wire Value 0 (pilot wire disabled) or 1 (pilot wire enabled)
3
Ambient Adjustable from -5.0°C to 5.0°C in 0.5°C steps
4
temperature
calibration
Selection of Value 1 (receiver unit) or 2 (remote control)
5
temperature See chapter 5.4
sensor
boost
mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode
None
6
7 Value 0 (unpaired command) or 1 (paired command)
Re-pairing
radio-
frequency
"
Default Value 0 (time) or 1 (temperature setting)
8
display
9 Display Back to factory settings
version
Warning!
number and All your settings as well as the pairing, will be deleted.
reset (unpai- If the remote control was paired before the reset,
+ or - key
ring). the receiver unit will also be reset.
+ or - key
Display para- Quit the settings menu
End
meter setting
output
+ or - key
quit the advanced parameters and turn off.
40019121 02/2019
Default
setting
1
0.0
1 or 2
--
rF0 or rF1
1
x.xx
Version number Reset
one minute, the remote control will automatically
Setting
Press the + or - key
Press the + or - key
Press the + or - key
Press on + or - key to
re-pair an appliance
which was previously
paired but has lost the
link.
Press the + or - key
Press on + key for 10
seconds to reset.
Short press on
mode or for 2
seconds on .
65