Status Of Led; Remote Control Displays - Zehnder 40019309 Notice D'utilisation

A) Procedure using the receiver unit on your appliance:
Press twice on the LED on your appliance (4 seconds max for the
2 presses).
The LED is .
You then have one minute to pair your appliance with the remote
control.
B) Remote control procedure:
(if the remote control screen is off, turn it on by pressing a key)
Press for
5 seconds
on the +
boost boost
mode mode mode mode mode mode
boost
mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode mode
If pairing fails, the display on the
rF 0 . Start the pairing
procedure again by pressing the +
If the radiator is still not paired to the remote control
after three attempts, the remote control
and receiverneed to be reset
(see chapter 8.3).
If the remote control is too far away from the heating appliance, the latter will continue to
operate in the last mode sent by the controller. Changes of mode relating to the opera-
tion of a programme or manual boosts will however continue as normal.
The appliance will resume normal operations within a few seconds when the remote
control is within range again (within 10 metres).
54
NOTE:
Operations A and B
can be done in any
order.
Appliance
search
about one
boost
minute.
mode
Pairing
complete.
The remote
control goes
boost
mode. The
mode
Synchronisation
the date and time are set.
A remote
control which has
5 seconds.
already been paired
cannot be paired again.
If an attempt to do so
is made, the receiver
flashes white
3 times.
4.3 Status of LED (on radiator or towel dryer)
STATUS
COLOUR
Green
Red
Blue
Yellow
Pink
boost

4.4 Remote control displays

mode
boost
mode
NOTE:
5 seconds.
The screen goes to standby after 1 minute.
The standby mode does not affect the functioning of the radiator, and pressing
The screen must be on for the pressing of a key to have an effect (e.g.
temperature setting, changing a parameter, etc.).
40019121 02/2019
Fixed Flashing
Eco mode
Comfort mode Boost
Open window
Load shedding (pilot wire) detected
(+ colour
sequence)
T° override°
Error: contact
after-sales service
Pairing error /
Pairing underway
Appliance not paired
Operating Modes
Scroll through times of day (prog)
Off
Standby
Powered down
Stop (pilot wire)
Stop load
shedding (pilot
wire)
Setpoint
temperature
55