6H. Modbus - Motive NEO-WiFi Manuel Technique

To know the SW version of your keypad, press the button , the SW version will appear on the upper right of the display (in
the example in the picture the SW version of the keypad would be 4.11). Do this operation with the inverter switched off.
To know the SW version of your NEO-WiFi, switch on the inverter and then the keypad by pressing the button .
Wait a few seconds to allow the keypad to communicate with the inverter, when the inverter goes in communication with the
keypad, the POWER led lights up.
The SW version of the inverter will appear on the upper right of the display (in the example shown in the picture, the SW version of
the NEO-WiFi-3 would be 4.08).

6h. MODBUS

107/138 NEO-WiFi – manual - FRA REV20-LUG21