Trouble Shooting - Parkside PHD 110 A1 Traduction Des Instructions D'origine

GB IE

Trouble shooting

Problem Possible cause
ON / OFF switch (
turned off
Washer
Damaged power supply cable
is not
A
(
operating
Mains fault
Washer
does not Air trapped in the pressure
transport washer
water
Air trapped in the pressure
Washer
washer
does not ge-
nerate any
Drop in the water mains
pressure
pressure
Severe
High-pressure nozzle (
pressure
is dirty
fluctuations
28
A
8)
Remedy
17) is
Check ON / OFF switch.
Check power supply cable (
damage. If necessary have the power
supply cable replaced by a qualified
electrician.
Check the electrical system for conformi-
ty with the data on the rating plate.
Switch on the equipment and pull the
lever of the gun (
Bleed the equipment, see steps 5. - 8.
Turn on the washer with high-pressure
hose until bubble-free water flows out of
the high-pressure connection (
Check the water mains.
Rinse the high-pressure nozzle (
12) with water. If necessary clean the
A
12)
nozzle hole with a needle.
Clean the high-pressure nozzle (
with the nozzle cleaning pin.
A
8) for
A
4).
A
7).
A
A
12)