Technical Specifications - Perel LEDS15RGB Mode D'emploi

1. To (re)place the battery, press on the side of the battery cover [D1]
and pull [D2] to slide it open.
2. Insert the battery with the correct polarity and close the battery
compartment by pushing it back into the housing of the remote control
until it snaps into place.
Warning: Do not puncture batteries or throw them in fire as they
may explode. Do not attempt to recharge non-rechargeable
batteries (alkaline). Dispose of batteries in accordance with local
regulations. Keep batteries away from children.

7. Technical Specifications

IP rating
coating
colour
wavelength
light output
viewing angle
LED spacing
power supply
dimensions
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device. For more info concerning this product
and the latest version of this manual, please visit our website
www.perel.eu. The information in this manual is subject to change
without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 03 – 22/11/2017
LEDS15RGB/LEDS18RGB/LEDS19RGB
LEDS15RGB
IP61
PU glue
R=625 nm, G=525 nm, B=475 nm
± 300 lm/m
3 m x 10 mm
LEDS18RGB
IP20
red-green-blue
± 370 lm/m
120°
33 mm
12 VDC/24 W (adapter included)
5 m x 10 mm
5
LEDS19RGB
/ PU glue
± 300 lm/m
5 m x 10 mm
©Velleman nv
IP61