Iv- Remote Control; Installing The Battery Into The Remote - CONTINENTAL EDISON CETDSB40B4 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IV – REMOTE CONTROL

1. Installing the battery into the remote

1. Before starting to use the remote, activate the button cell by removing the
protective paper located inside the battery compartment.
Note: The 3V type CR2025 button battery is supplied
2. To replace the battery, open the battery compartment and insert a new battery of
the same type.
WARNING
Explosion hazard if the battery is not replaced properly.
Replace batteries only with the same or equivalent type.
Note: Use the remote within 5 meters of the unit, and aim it at the unit at an angle not
exceeding 30°.
WARNING
Do not ingest the battery to avoid chemical burns.
The remote control supplied with the sound tower contains a button
battery. Swallowing the button cell can generate serious internal burns
within only 2 hours, and can even provoke death.
Keep new and used batteries out of the reach of children.
If the battery compartment fails to close properly, stop using the remote and
keep it out of reach of children.
In case of doubt whether the batteries have been swallowed or introduced
into any part of the body, please consult a doctor without delay.
31

Publicité

Chapitres

Table des Matières
loading

Table des Matières