Balluff IO-Link BIC 1B1-IT1A0-M30EI21-SM4A5A Notice De Montage page 5

BIC _B1-IT1A0-M30EI21-SM4A5A
Inductive couplers
Display elements
LED 1 (operating status and communication)
Signal
Base component
Green alternating IO-Link communication on the
with LED off at ratio diagnostic channel is active. The
of 10:1, 1 s period device is ready.
Static green The device is ready.
Remote component
Static green The device is ready, Base-
Remote communication is
working properly.
Green flashing, 3 Hz The device is ready, but Base-
Remote communication is not
available.
LED 2
See document IO-Link configuration under
www.balluff.com on the product page.
Electrical connection
Cable length
For IO-Link operation, the maximum cable length is 20 m.
1
BIC 1B1-IT1A0-M30EI21-SM4A5A
(Base)
2 4
Connector diagram (top view of M12
plug on Base)
3
Pin Signal
1 L+ (operating voltage +, IO-Link 21.6...26.4 V)
2 1) I/Q (digital input / digital output), C/Q (IO-Link
diagnostic channel)
3 L− (operating voltage −)
4 C/Q (IO-Link communication)
1)
Pin 2 functions as a transparent, bidirectional digital IO channel
between Base and Remote. An additional Y-splitter is required for
an IO-Link diagnostic channel (communication channel for the
diagnostic data of the BIC system via IO-Link) (see User's Guide).
2
BIC 2B1-IT1A0-M30EI21-SM4A5A
(Remote)
5
1 3
Connector diagram (top view of M12
socket on Remote)
4
Pin Signal
1 L+ (operating voltage +, IO-Link 18...30 V)
2 I/Q (digital input / digital output)
3 L− (operating voltage −)
4 C/Q (IO-Link communication)
5 Not used
www.balluff.com
Meaning
Installation
CAUTION
Danger of burns from hot surfaces
The housing and especially the active surface will heat up
under normal operating conditions. There is a risk of burn
injuries! The heat must therefore be dissipated in the best
possible way.
► Select heat dissipating fastenings (metallic clamps
with large surface area) or ensure good ventilation
and dimensioning of the system.
NOTICE
Product damage
In metallic environments there is a risk of damage to the
BIC system due to induction effects.
► Make sure that distances from metallic objects are
observed!
Minimum distances to avoid mutual interference
A = > 70 mm
Minimum distances for installation in metal
A = > 20 mm (lateral
B = > 15 mm (distance from
Active surface
► Mount the BIC system in such a way that the distances
are observed and that the best possible heat
dissipation can be achieved (through well-chosen
fastenings (metallic clamps with large surface area) or
through good ventilation and dimensioning of the
system.
► stall the components so that there are no metallic
objects in the zone resulting from distances A and B.
The distances A and B must be maintained
independently of each other!!
distance)
active surface to rear
mounting surface)
english 2