Salli Professional Mode D'emploi page 14

DISASSEMBLING SALLI
You should use special tools for disassembling Salli. You can borrow the tools from your Salli dealer.
REMOVING THE SEAT
1. Set the gas cylinder in its longest position.
2. Turn the chair upside-down.
3. Place the semicircular tube of the disassembling tool at the junction of the gas
cylinder and the seat, so that the wedge-shaped end points towards the base.
4. Lift the chair a little off the floor. This is easier if another person holds the chair
up for you.
5. Hold the tool handle in position and hit the cantilever with a hammer until the
seat separates from the gas cylinder.
REMOVING THE BASE
1. Ask someone to hold the chair up for you, seat downwards.
2. Position the disassembly bar tool at the bottom of the gas cylinder.
3. Hold the the tool in position and hit the free end with a hammer a few times,
until the cylinder separates from the base.
MAINTENANCE, RECYCLING AND DISPOSAL
The Salli Saddle Chair is designed for indoor use at normal room temperatures in a dry environment. For humid envi-
ronments we recommend the rustproof Salli Stainless, as a normal gas cylinder will corrode if exposed to moisture.
To properly dispose of a Salli:
1. Remove the leather from the seat and discard.
2. Remove plastic and foam parts, including padding,
control lever handle(s) and the mechanism's
plastic parts, plastic castor components (the metal
stem of the castor can be removed e.g. in bench
vice with a hammer and a chisel). Dispose of plas-
tic components in an appropriate way with other
plastic garbage.
3. Recycle metal chair parts.
SALLI AND ERGONOMICS
EN
Your sitting-related ailments have taken years or even decades to develop. The new ergonomics will start the positive
change in your body immediately, but the deeper and wider impacts take time. For example, correcting your posture
will take years. However, you will notice the first positive effects already after two weeks.
SITTING DOWN ON SALLI
Before you sit down, make sure that the chair is not too high for you. The chair
should be lower than your pelvis. If the chair is too high, lift up the lever and at the
same time press down hard on the seat by your elbow or stomach. Once the seat is
at the correct height, release the lever.
Stand beside the chair and lift one foot up over the back of the chair to the other side
(Picture) and sit down. You may want to hold onto the chair with your hand while
sitting down. This way the chair will not roll away from you and you will find the right
sitting position easily.
14
ACCESSORIES
Multiple accessories for different
purposes are available for Salli
Saddle Chairs.
Visit www.salli.com for more details.
Do not sit down on the chair the traditional way, i.e. from in front
of the chair with your buttocks foremost. The chair might slide
away and you might fall. You will also end up in the wrong sitting
position on the front edge of the chair.
Make sure that you don't accidentally move the chair away
when you lift your foot over it.
Salli Saddle Chairs are higher than traditional chairs.
WARNING!