hardware setup
1
monitor connection
2
to camera
6.
Installation
Refer to the illustrations on page 2 of this manual.
7.
Technical Specifications
camera
pick-up element
scanning system
number of pixels
resolution
min. illumination
light wavelength
number of LEDs
effective range
IR power on
IR LEDs
synchronisation system
interlace
video output signal
video S/N ratio
white balance
auto electronic iris (AES)
backlight compensation
gamma correction
lens
lens angle
operating environment
storage environment
IP rating
power supply
power consumption
dimensions
weight
power supply via coax cable
camera power supply system
maximum cable length
power consumption
power supply
dimensions
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our
website www.velleman.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 02 – 11/09/2012
CAMCOLBUL32
3
to monitor
4
AC power cord
5
coaxial power supply
1/3" Sony Exview HAD CCD sensor
PAL
537 (H) x 597 (V) - PAL -
520 TV lines
0.01 lux / 0 lux (with IR LEDs on)
400 - 850 nm IR
54
50 m
CDS auto control activates LEDs when ambient light < 10 lux
wavelength: 840 nm; angle: 40°; power: 200 mW
internal sync.
2:1 interlace
1.0 Vpp, 75 ohm, composite
> 52 dB (AGC off)
yes
1/50 - 1/100000 sec.
yes
0.45
f6 mm / F2.0
53°
temperature: -10°C to +50°C, humidity: < 90% RH
temperature: -20°C to +70°C, humidity: < 70% RH
IP68
DC power supply through coaxial cable
4 W
110 x Ø 75 mm
2.9 kg
DC constant current via coaxial cable
300 m of RG-59U cable
6 W
230 VAC ~ 50 Hz
218 x 44 x 96 mm
4
©Velleman nv