Changing The Gas Cylinder - Krampouz Saveur Notice D'utilisation

instructions supplied with the pressure regulator and hose. Then, perform a leak-
tightness test by following these instructions:
− Check leak-tightness by using soapy water away from any heat source
(cigarettes, electrical appliances, etc.).
− Never test leak-tightness using a flame.
− Put soapy water on all couplings, open the gas inlet and then check for the
formation of bubbles.
− If bubbles = leak; close the gas cylinder and tighten the couplings, then perform
another leak-tightness test.
− If the leak persists or comes from another part, stop using your plancha and
contact the dealer.
Never use a leaky appliance.

CHANGING THE GAS CYLINDER

Always change the gas cylinder with the control levers and the gas cylinder valve
closed.
Change the gas cylinder in a well-ventilated location away from any heat source
(cigarettes, electrical appliance, etc.).
Whenever you change the gas cylinder, perform a leak-tightness test.
Use
POWERING ON
− The appliance is ready for operation
− Open the gas cylinder valve
− Open the plancha valve by turning the lever to the high flame position (drawing
on the ring around the lever).
− Push the lever to this position against the frame for a few seconds, then activate
the electronic lighter to switch the burner on. Check that the burner is
completely lit by looking through the openings on the side of the appliance.
− Maintain pressure on the lever for between 5 and 10 seconds to engage the
thermocouple safety system (see figure 5).
− Then release the lever and allow the burner to heat the cooking plate to the
appropriate temperature.
− Preheat the plancha by setting it to the high flame position for 5 to 10 min, then
reduce to the low flame position.
− Your appliance is ready to be used.
COMMENTS
The first time it is used, it may be normal to see some smoke and smell some odours
coming from the appliance. This is normal.
- 19 -