Replacing Discs While Playing A Disc; Locating A Specific Disc - Sony SCD-C333ES Mode D'emploi

Replacing Discs While
Playing a Disc
You can open the disc tray while playing a disc so that
you can check what discs are to be played next and
replace discs without interrupting play of the current disc.
1
Press EX-CHANGE.
The disc tray opens and two disc compartments
appear. Even if the player is playing a disc, it doesn't
stop playing.
2
Replace discs in the compartments with new ones.
The player plays the disc on the left side compartment
after the current disc, and then the one on the right
side compartment.
3
Press DISC SKIP.
The disc tray turns and other two disc compartments
appear.
4
Replace discs in the compartments with new ones.
5
Press EX-CHANGE.
The disc tray closes.
Note
Do not push the disc tray to close it in Step 5, as you may damage
the player.
While the disc tray is open by pressing the EX-CHANGE button
• If the play of the current disc ends, the player stops playing. If
the disc is played in 1 DISC Repeat Play mode (see page 17),
the current disc starts playing again.
• In ALL DISCS Shuffle Play mode (see page 18), tracks are
reshuffled on the current disc.
• In Program Play mode (see page 19), only the tracks on the
current disc are played.

Locating a Specific Disc

You can locate any disc before or while playing a disc.
DISC 1–5
EX-CHANGE
DISC SKIP
DISC SKIP +/–
To locate
The next disc
The next or succeeding
discs
The current or preceding
discs
A specific disc directly
DISC
Number
buttons
>10
Press
DISC SKIP while playing a disc
DISC SKIP + repeatedly until you
find the disc
DISC SKIP – repeatedly until you
find the disc
DISC 1–5.
When using the remote, follow the
procedure below.
1 Press DISC.
2 Press the number button of the
disc.
3 Press ENTER.
DISC SKIP
15
GB