Installation Of Device Software - REV MAX! Cube Mode D'emploi

Please note that in the case of some models, the USB volt-
age is no longer available once the device has been
switched off.
If the power supply to the MAX! Cube is interrupted,
the thermostats in the rooms continue to regulate
the temperature independently. The MAX! Cube
serves solely as the interface to the MAX! Software,
to a MAX! Eco Switch and as a central data store.
Attention: To avoid damaging the device, please only
use the original main adapter supplied with the
device for the power supply.
The MAX! Cube must be supplied with power and
connected to router for the installation of the MAX!
Software.
For the installation of your MAX! Cube, the DHCP
of your router has to be activated. Alternatively, the
following IP address can be manually allocated to
t h e M A X ! C u b e v i a t h e M A X ! S o f t w a r e :
192.168.0.222.
You need the MA X! PC program to teach-in MA X!
Components via the MAX! Cube, for configuration purposes
and to call up device status messages.
• Connect the cube to a router by plugging the network
cable supplied with the device into the designated port
on the side of the MAX! Cube. Connect the other end of
the cable to a free slot on your router.
• Open the Internet browser on your PC (the one on
which the MAX! Software is to be installed).
18
8. Installation of PC software &
system requirements