Teaching-In Max! Components; Power Supply - REV MAX! Cube Mode D'emploi

• Once the wall bracket is in place,
the MAX! Cube can be attached to
the wall bracket from above, with
the opening pointing down.

6. Teaching-in MAX! Components

In order to enable communication between MAX! Com-
ponents, the devices have to be taught-in to one another.
Devices are taught-in on the MAX! Cube with the user-
friendly MAX! PC software.
In the meantime, please allocate rooms to the taught-
in MAX! Components to avoid possible confusion.
The MAX! Cube draws its power supply from the plug-in
main adapter included in the scope of supply.
• Plug the USB main adapter supplied into a socket
outlet.
• Connect the MAX! Cube and the main adapter with the
USB cable. Use the USB port on the side of the device
(2) for this purpose.
Alternatively, power can be supplied to the MAX!
Cube via the USB port on a computer or a router.
• U se a pen to mark the bore hole po-
sitions (a) of the wall mount on the
wall.
• Use a drill to make the holes as
illustrated (a).
• Use the screws and plugs supplied
to fasten the bracket to the wall.

7. Power supply

17