Installing The Refrigerator - Dometic GROUP Waeco CoolMatic CRP-40 Notice D'utilisation

CRP-40.book Seite 29 Montag, 27. September 2010 4:07 16
CoolMatic CRP-40
6.1

Installing the refrigerator

In continuous operation, the air humidity may not exceed 90%.
Set up the fridge in a dry, sheltered place. Avoid placing it near heat sources
such as radiators, gas ovens or hot water pipes. Do not let it stand in direct,
strong sunlight.
The cooling device must be positioned so that heated air can dissipate easily.
Therefore make sure there is adequate ventilation (fig. 4, page 4).
No. in
fig. 4,
Explanation
page 4
1 Hot waste air
2 Cold intake air
3 Condenser
4 With decorative panel 50 mm space at the top!
I
Note
The cooling unit is detachable mad can be installed up to
1.5 metres away from the cooler if there is limited space.
6.2 Releasing the lock
The refrigerator has a locking mechanism (fig. 5 1, page 5) which is also
used to protect it during transport. The following settings are possible:
a
Caution!
Only adjust the locking mechanism when the door is open. If you
use it with the door closed, you will damage the device.
Normal lock (turn wheel clockwise to the end stop): the door is locked
and secured.
To open the door, lift the handle up and open the door.
Vent (turn wheel anti-clockwise to the end stop): The door is slightly open
and fixed in place.
Use this position, if you are not going to use the appliance for a long time.
Setting up and connecting the refrigerator
29