Before Commissioning - elem ASB40LI-2A Traduction Des Instructions D'origine

ASSEMBLY
WARNING: Switch off and
remove battery from machine
before adjusting or cleaning!
WARNING: Always wear
shoulder strap when operating
OPERATION

Before commissioning

Risk of injury! A device that has
not been assembled completely
can cause serious injuries.
Fully assemble the device
before you operate it
and connect it to the power
Wear personal protective
• Wear goggles.
• Wear ear protectors.
• Wear solid shoes and long trousers. Wear this
protective clothing at all times when the machi-
ne is being used. Do not operate the machine
with bare feet or with open sandals.
• Do not wear loose fitting clothing or clothing
with hanging laces or ties.
• Do not wear any hanging clothing or jewellery
that can be sucked into the vacuum opening.
• Keep long hair away from the vacuum openings
Operate the machine in a recommended position
and only on a fixed and even surface. Do not
operate the machine on a cobbled surface or on a
gravel surface where material that is ejected could
cause injuries.
Check the work area before using the appliance.
Remove any hard objects such as stones, shards of
glass, wires, etc. that could be thrown off, knocked
back or that could otherwise cause injury or damage
during appliance operation.
Always carry out a visual inspection before use.
The device must not be used if it is damaged, not
correctly installed or if the safety devices are
defective.
Replace any worn and damaged parts.
machine.
WARNING
supply.
WARNING
equipment.
Only use if the correct equipment is attached.
Never use the machine if the cover or protective de-
vice are damaged, or without the cover or protective
device. Replace damaged or illegible labels.
Operate the leaf vacuum using only the nozzle
and the connected collection bag. Replace worn
or damaged components.
Do not use this leaf blower near fire places or
BBQ places and open fire, ash pits, etc. A proper
use of the leaf blower contributes to fire spread
avoidance.
Do not work near open
Do not put any objects on the lance blow ope-
nings. Make sure the blown material is not being
blown at persons, animals, glass sheets or solid
objects such as trees, cars, walls, etc. Strong air
flow could throw off stones, dirt or rods or they could
be bounced off the ground and injure persons,
animals, break glass sheets or cause other damage.
Never use the appliance to disperse chemicals,
fertilisers or other substances. By this, you will
avoid toxic material spread.
Operation
Start and stop
Start up of the machine: press the switch to "I"
▪
(ON).
Stopping the machine: press the switch to "O"
▪
(O
How to hold the machine and guide it whilst
working
Whilst working, always place yourself behind the
machine and hold it firmly with both hands on
the handles.
Speed regulation
This machine has a speed regulator with which you
can control the speed of the blowing air and that of
the vacuum air. To regulate the speed turn the
regulator "1" to "MAX" depending on whether you
want more or less speed.
Working with the blowing function
Start the machine and aim the air flow towards
▪
the leaves and materials to be pushed.
Push all the material towards one place which
▪
preferably should be a corner.
Once all the material has been grouped for pick
▪
up, turn the machine off, switch to vacuum
function, start the machine again and begins to suck
the materials.
WARNING
windows etc.
28