Additional Safety Instructions For Batteries And Chargers - elem ASB40LI-2A Traduction Des Instructions D'origine

ADDITIONAL SAFETY
INSTRUCTIONS FOR BATTERIES
AND CHARGERS
Use only batteries and chargers
applicable for this machine.
Never attempt to open for any reason.
Do not store in locations where the temperature
may exceed 40 °C.
Charge only at ambient temperatures between
4 °C and 40 °C.
Do not cause short circuits. If connection is
made between the positive (+) and negative (-)
terminal directly or via accidental contact with
metallic objects, the battery is short circuited
and an intense current will flow causing heat
generation which may lead to casing rupture or fire.
Do not heat. If batteries are heated to above
100 °C, sealing and insulating separators and other
polymer components may be damaged resulting in
electrolyte leakage and/or internal short circuiting
leading to heat generation causing rupture or file.
Moreover do not dispose of the batteries in fire,
explosion and/or intense burning may result.
Under extreme conditions, battery leakage may
occur. When you notice liquid on the battery,
proceed as follows:
Carefully wipe the liquid off using a cloth. Avoid
skin contact.
In case of skin or eye contact, follow the
instructions below:
Immediately rinse with water. Neutralize with a
mild acid such as lemon juice or vinegar.
In case of eye contact, rinse abundantly with
clean water for at least 10 minutes.
Consult a physician.
Ne pas brûler le chargeur et le
Ne pas exposer le chargeur et
le pack-batteries à des
supérieures à 50 °C.
Ne pas exposer le chargeur et
le pack-batteries à l'humidité.
Chargers
Never attempt to charge non-rechargeable
batteries.
Have defective cords replaced immediately.
Do not expose to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
pack-batterie
températures
CHARGING AND INSERTION OR
REMOVAL OF BATTERY
Note: if the battery does not fit
properly, disconnect it and
battery pack is the correct
model for this charger as
shown on the specification
chart. Do not charge any
other battery pack or any
battery pack that does not
securely fit the charger.
1. Frequently monitor the charger and battery
pack while connected
2. Unplug the charger and disconnect it from the
battery pack when finished.
3. Allow the battery pack to cool completely
before using it.
4. Store the charger and battery pack indoors, out
of reach of children.
NOTE: If battery is hot after
continuous use in the tool,
allow it to cool down
to room temperature before
charging. This will extend the
Pictograms on charger
The following pictograms have been applied to the
charger:
"Class II - The machine is double
insulated; Earthing wire is
therefore not necessary
Only use the battery charger
indoors.
Fail-safe isolating transformer.
Cut-out switch.
Removal / insertion of battery
WARNING: Before making any
adjustments ensure the tool is
switched off or remove the
Hold the tool with one hand and the battery
pack (10) with the other.
To install: push and slide battery pack into
battery port, make sure the release latch on the
rear side of the battery snaps into place and battery
is secure before beginning operation.
To remove: Press the battery release latch and
pull the battery pack out at the same time.
confirm that the
life of your
batteries.
battery pack.
27