Measurement Results; How To Maintain And Store The Unit; How To Prevent A Malfunction - VISIOMED BewellConnect MyTensio BW-BA1 Mode D'emploi

Do not remove the armband before the 3 blood pressure measurements. The measurements
are automatically sent to the app via Bluetooth 4.0.
- Once the measurements have been taken, the average of the 3 is displayed on the app screen.
- Press the ON/START to turn it off. The unit automatically turns off after approximately 1 minute.
- To determine which arm you will continue to take readings on, do both on your first reading.
In the event of asymmetrical blood pressure (right systolic blood pressure-left systolic blood
press >20 mmHg), take reading from the arm with the highest value except in the event of
contraindications in this arm.
Notes :
- The measurement will be too low if the armband is higher than the heart or too high if it is lower than
the heart.
- If you want to stop the blood pressure measurement at any point, press the ON/START to turn it off.
- Speak to your doctor if you have any questions about using the blood pressure monitor.

4-9. MEASUREMENT RESULTS

The app automatically evaluates the MAM (Measurement Average Mode) and uses WHO color
grading to provide the result.

5. HOW TO MAINTAIN AND STORE THE UNIT

- Use a dry soft cloth to clean the unit. If necessary, use a cloth lightly dampened with tap water.
- Do not use alcohol, benzene, thinner or other harsh chemicals to clean the device or cuff.
- Before using please wash your hand. Do not wash or wet the cuff.
- Avoid placing the unit where there is direct sunlight, high humidity or dust.
- Roll up the pressure armband and store in its case.

6. HOW TO PREVENT A MALFUNCTION

- Do not drop the device and avoid sudden jars or shocks.
- Do not insert other objects into any holes.
- Do not attempt to disassemble the unit.
- Do not put the unit in water.
- The monitor might not meet its performance specifications or may cause safety hazard if
stored or used outside the specified temperature and humidity ranges in specifications.
BewellConnect - BW-BA1 - User Manual - 122016V1 13