Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14. Never leave tool running unattended. Turn power off.
Don't leave tool until it comes to a complete stop.
15. Carefully handle power tools.
Should a power tool be dropped or struck against hard materials inadvertently,
it may be deformed, cracked, or damaged.
16. Do not wipe plastic parts with solvent.
Solvents such as gasolie, thinner, benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry
thoroughly.
17. NEVER touch the tool bit with bare hands after operation.
18. NEVER wear gloves made of stuff liable to roll up such as cotton, wool, cloth or
string, etc.
19. ALWAYS attach the side handle and securely grip the Rotary Hammer.
20. ALWAYS be careful with buried object such as an underground wiring.
Touching these active wiring or electric cable with this tool, you may receive an
electric shock.
Comfirm if there are any buried object such as electric cable within the wall,
floor or ceiling where you are going to operate here after.
21. Definitions for symbols used on this tool
V ............. volts
Hz ........... hertz
A ............. amperes
n
o .......... no load speed
W ............ watt
............ Class@Construction
---/min .... revolutions per minute
English
7
Publicité
Table des Matières
